Changing the Preset Temperature
1. To adjust the “Preset” temperature enter the
User menu by pressing and holding the Set
button for more than 5 but less than 10
seconds.
2. Rotate the dial until Pr is shown.
3. Press the set button and the display will show
the current Preset setting.
4. Rotate the dial clockwise to increase the Preset
temperature & anti-clockwise to reduce the
Preset temperature.
5. Press the Set button to confirm and Pr will be
displayed.
NOTE: When adjusting the settings within the
menu, if the maximum or minimum possible set-
ting are reached, the display will flash to indicate
you cannot adjust the product further, e.g. you
cannot set the Preset higher than the maximum
temperature setting.
To return to normal operation, either press the Set
button for more than 5 seconds or wait for 1
minute and it will return automatically.
DIGISTAT ROOM THERMOSTAT
ADVANCED SETTING
OPERATING & INSTALLATION
INSTRUCTIONS
6
DT20RF PROGRAMMER
INSTRUCTION MANUAL
8 716 115 495a (02.2009)
To Next Page
Loading...
Need help?
General