14
Fault Finding
Greenstar Ri
ErP
- 6 720 813 340 (2014/09)
7.1 Boiler reset
In the event of a fault, the blue mains indicator light will flash if there is a fault.
To reset the boiler:
▶ Turn the Central heating temperature knob[1] anticlockwise to the “RESET” position [2] and hold for approximately five
seconds and then turn the knob back to the original temperature setting.
▶ When the boiler resets the mains indicator [3] will no longer be flashing and the boiler will function normally, dependant on the
programmer and room thermostat settings.
A reset fault condition will exist If the electrical power to the boiler has been interrupted. Reset the boiler as described above.
Fig. 7 Reset button and mains light
If the fault remains and cannot be cleared by resetting the boiler, contact Worcester, Bosch Group for assistance.
6720813340-04.1Wo
1
2
3
To Next Page
Loading...
