Workhorse Flashback - Page 6

6
PRINT FLASH / PRINT FLASH (connued)
That same Print head can be selected to double stroke which means when prinng, the head will ood the screen, the
tables will raise and Print then the tables will lower and then the ash will extend in and automacally reverse. The
squeegee will then ood the screen while the ash is extending and retracng waing for the element to return to its
home posion so the table can raise and make the second print stroke. Aer it makes it second stroke the tables will
lower again and the ash will extend. This will only happen in Automac mode as the printer will not double stroke in
Manual mode. While in Auto mode though, you will not normally want the table to turn before it ashes the second
stroke so you will either need to run the machine in Foot Pedal mode or turn the Delay me to around the 8 second mark
allowing for the image to be completely ashed.
4. Flash Table Up/ Down: *WARNING*
FLASH TABLE UP / FLASH TABLE DOWN
The Flashback can be used for two dierent ways of ashing.
You are able to Print Flash and cool down all in one spot. This is Flash Table Down, in this mode it will not allow the machine to
raise while the element tray is extended out in between pallets and Screen.
The second mode is as a Standard style or in head ash, this is Flash Table Up. This mode will allow the table to raise while the
element is extended out above a pallet There are steps needed to be made for this to work right with out damaging the bulbs.
Remove the front clamp from the machine by rst disconnecng the 5/32” airlines and then removing the ½-13 ange nuts. This
will allow you to leave the micro aached to the press.
Then raise the Flashback by loosening the front levers and turning the knob and slowly raise the front, do this in increments where
you then loosen the back levers and raise it up by turning the knob. You will want to raise the Flashback 2 inches or so above the
pallet, this will allow for clearance over the pallet when the table is raised. However before allowing the table to raise with the
element extended you will want to measure the distance between the boom of the element to the top of the pallet, it must be
more than 2 inches.
5. Extend:
The extend control is a ow control that increases or decreases the air supply to the Flashback tray enabling you to slow or speed
up the elements extend stroke. This is done by turning the knob clockwise for slower, or counter clockwise for faster.
6. Retract:
The Retract control is a ow control that increases or decreases the air supply to the Flashback tray enabling you to slow or speed
up the elements retract stroke. This is done by turning the knob clockwise for slower, or counter clockwise for faster.
Note: Do not ash pellons they will burn , all pellons burn.