Workhorse Flashback - Controls

5
1. Heat On/O: This turns on or o the elements and the blower motors.
2. Auto Flash On/ O: When on this will automacally extend and retract the element tray in sequence with the tables rotaon. In
the o posion the ash will remain retracted when no ash is needed.
3. Mode Selecon;
PRINT FLASH PRINT
This funcon allows the ash to extend in double mode only; the idea behind it is pung a one color on a dark shirt with
no other images to be applied. If the machine is set to single stroke the Flashback will not ash.
The machine will ood then the table will raise and make the Print stroke then lower, the ash will extend in
automacally and retract. It will ood as the element is extending in and out so when the element tray has returned to
its home posion it will the raise and makes its second print stroke. Aer that has happened, the ash will not extend
again and the tables can turn immediately there is no need for delay at this point.
PRINT PRINT FLASH
This funcon allows for the printer to make two Strokes on a screen and then ash the design before the tables turn. So
the machine will ood the screen, then the table will raise and Print, aer, it will lower and ood again then the table
will raise and make the Print stroke the second me. Aer it makes the second Print stroke the machine will lower and
the ash element will extend in and automacally reverse.
The Delay mer will need to be set at around the 8 second mark to allow for the ash to extend and retract before the
tables turn again.
PRINT FLASH / PRINT FLASH
This funcon allows the ash element to extend in and out aer every print stroke.
So if the Print head is selected to a single stroke the machine will ood the screen, the tables will raise make a Print stroke
and then the table will lower. When the machine lowers back down the Flashback will then get a signal to Flash. (The
FLASHBACK will extend in and automacally reverse its self back to its home posion).
Connued On Next Page
1 2 3 4 5 6