Workhorse W Series User Manual

WORKHORSE CUSTOM CHASSIS
Service Manual
W SeriesWCC
SECTION
6.2
PAGE
70
Engine Mechanical
W Series Chassis
TOC
© 2006 WorkhorseCustom Chassis — All Rights Reserved
Assembling Components
• Assemble components using only the sealant (or equivalent) that is specifi ed in the service procedure.
• Sealing surfaces must be clean and free of debris or oil.
• Specifi c components such as crankshaft oil seals or valve stem oil seals may require lubrication during assembly.
• Components requiring lubrication will be identifi ed in the service procedure.
• Apply only the amount of sealant specifi ed in the service procedure to a component.
• Do not allow the sealant to enter into any blind threaded holes, as the sealant may prevent the fastener from clamping
properly or cause component damage when tightened.
Important: Do not overtighten the fasteners.
• Tighten the fasteners to the proper specifi cations.

Workhorse W Series Specifications

General

Brand	Workhorse
Model	W Series
Category	Engine
Language	English