TROUBLE SHOOTING
RECYCLING AND DISPOSAL
15
Overheating.
Follow all safety precautions whenever diagnosing or servicingthe tool.
Disconnect power supply before service.
Waste electrical produsts should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority of local store for recycling advice.
Tool does not sand
or polish effectively.
1. Forcing tool to work too fast.
2. Blocked motor housing vents.
3. Motor being strained by long or
small diameter extension cord.
1. Disc accessory may be
loose on Spindle.
2. Disc accessory may be damaged,
worn or wrong type for the material.
3. Wax sprays off polishing pad.
1. Allow tool to work at its own rate.
2. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
3. Eliminate use of extension cord.
If an extension cord is needed, use one with
the proper diameter for its length and load.
1. Be sure disc accessory arbor is correct
and outer flange/arbor nut is tight.
2. Check condition and type of disc accessory.
Use only proper type of disc
accessory in good condition.
3. Reduce RPM to minimum setting.
To Previous Page
Loading...