EasyManua.ls Logo

WorkPro W125020A - Additional Specific Safety Instructions

WorkPro W125020A
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RISK OF PERSONAL INJURY:
CAUTION: TO REDUCE THE RISK OF
INJURY OR PROPERTY DAMAGE:
Always use proper guards when grinding and wear
eye protection. Use only accessories rated at least
4000/min.
Failure to properly seat the bonnet to the pad may
result in the bonnet being thrown from the pad.
Always maintain a firm grip on the Waxer/Polisher
handle(s) to prevent loss of control.
Do not use tool if ON/OFF Trigger does not turn it
ON or OFF. Any tool that cannot be controlled with
the power switch is dangerous and must be
repaired.
Operate this waxer/polisher ONLY on AC current
on which the voltage is within correct limits (120
volts). Never attempt to operate on DC current. To
do so may seriously damage the waxer/polisher.
Always disconnect the unit’s cord plug from power
source before making any adjustments, changing
bonnets or storing the tool to reduce the risk of
accidentally starting the waxer/polisher.
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that may affect the waxer/polisher’s operation. If
damaged, have the tool serviced before using.
Use only accessories that are supplied or
recommended by the manufacturer for this model.
Refer to the “Accessories” section of this Instruc-
tion Manual for more information.
NEVER allow Gasoline, Brake Fluids or any
petroleum-based products to come in contact with
plastic parts or power cord. They contain
chemicals that can damage, weaken or destroy
plastic and insulation.
Make sure that adjusting keys and wrenches are
detached from the unit before turning it ON.
Use clamps or another practical way to secure and
support the work piece to a stable platform. Holding
the work by hand or against your body is unstable
and may lead to loss of control.
Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory
or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust
exposure. Keep direct particles away from face and
body.
Note: Only those dust masks suitable for working
with lead paint dust and fumes should be used.
Ordinary painting masks do not offer this protection.
See your local hardware dealer for the proper
NIOSH/OSHA approved mask.
ADDITIONAL SPECIFIC SAFETY INSTRUCTIONS
7
WARNING!