Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury. Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
WARNING!
SERVICE
IMPORTANT SAFETY INSTRUCTIONS
SAFETY WARNINGS
This product is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the product by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the product.
TAKE SPECIAL CARE TO GUARD
AGAINST THESE DUSTS, INCLUDING
THE FOLLOWING:
All persons entering the work area must wear an
approved mask specially designed for protection
against harmful / toxic dusts, in addition to using the
dust extraction facility, and keeping work area well
ventilated.
Children and pregnant women must not enter the
work area.
Do not eat, drink or smoke in the work area.
To reduce the impact of noise and vibration emission,
limit the time of operation, use low-vibration and
lownoise operating modes as well as wear personal
protective equipment.
Take the following points into account to minimize
the vibration and noise
exposure risks:
VIBRATION AND NOISE REDUCTION
Switch off and disconnect from the power supply if
there are malfunctions. Have the product checked by
aqualified professional and repaired, if necessary,
before you operate it again.
Familiarise yourself with the use of this product by means
of this instruction manual. Memorise the safety directions
and follow them to the letter. This will help to prevent risks
and hazards.
EMERGENCY
Only use the product as intended by its design and
these instructions.
Ensure that the product is in good condition and well
maintained.
Use correct application tools for the product and
ensure they in good condition.
Keep tight grip on the handles/grip surface.
Maintain this product in accordance with these
instructions and keep it well lubricated (where
appropriate).
Plan your work schedule to spread any high vibration
tool use across a number of days.
Always be alert when using this product, so that you
can recognise and handle risks early. Fast intervention
can prevent serious injury and damage to property.
1.
2.
3.
4.
5.
6.
Tool service must be performed only by
qualifiedrepair personnel. Service or maintenance
performed by unqualified personnel may result in a
risk of injury.
When servicing a tool, use only identical replace-
ment parts. Follow instructions in the Mainte-
nance section of this manual. Use of unauthorized
parts or failure tofollow Maintenance Instructions
may create a risk of shock or injury.
To Next Page
Loading...