Workshop WS1400CA User Manual

8
DRUM/CADDY ASSEMBLY (continued)
WET/DRY VAC ASSEMBLY
1. Position the Powerhead Assembly on
the Drum/Caddy Assembly, as shown
(assembled earlier).
2. Rotate both Latches down and press
until you hear them snap over the
Flanges on the Drum.
Drum
Latch
Drum
Latch
Drum
Flange
Latch
Drum
Powerhead
Assembly
Insert Hose
Insert the Release Button end of the
Dual-Flex™ Locking Hose into the Vac Inlet
of the Vac. The Hose should snap into place.
To remove the Hose from the Vac, press the
Release Button on the Hose Assembly and
pull the Hose out of the Vac Inlet, as shown.
Release
Button
Press
and Pull
Vac Inlet
Accessory Bag Snaps
Accessory
Bag Straps
(4)
Handle
Installing Accessory Bag
Install Accessory Bag by wrapping the
Four Accessory Bag Straps around the
Metal Handle and Snap each Strap in
place, as shown.
SP6852-2 Workshop 14 Gallon.qxp_WS1400CA0 8/27/18 3:37 PM Page 8

Workshop WS1400CA Specifications

General

Brand	Workshop
Model	WS1400CA
Category	Vacuum Cleaner
Language	English