WORKZONE TITANIUM PREMIUM HC520 - 8. Assembling and Operation (Page 12)

17
Before starng the equipment/Assembling and operaon
7. Before starng the equipment
m Aenon!
Before you connect the equipment to the mains supply make sure that the data on
the rang plate are idencal to the mains data.
• Check the equipment for damage which may have occurred in transit. Report any
damage immediately to the transport company which was used to deliver the
compressor.
• Install the compressor near the point of consumpon.
• Avoid long air lines and supply lines (extension cables).
• Make sure that the intake air is dry and dusree.
• Do not install the compressor in a damp or wet room.
• The compressor may only be used in suitable rooms (with good venlaon and an
ambient temperature from +5 °C to 40 °C). There must be no dust, acids, vapors,
explosive gases or inammable gases in the room.
• The compressor is designed to be used in dry rooms. It is prohibited to use the
compressor in areas where work is conducted with sprayed water.
• The oil level in the compressor pump has to be checked before pung the
equipment into operaon.
8. Assembling and operaon
m Warning!
Prior to any adjustment work disconnect the mains power plug!
m Important!
You must fully assemble the appliance before using it for the rst me!
You will require the following tools for assembly and installaon: 2 x open-ended
wrench size 17 mm (not included)
8.1 Fing the wheels (Fig. 5)
• Fit the supplied wheels as shown.
8.2 Fing the supporng foot (Fig. 6)
• Fit the supplied supporng foot as shown.
8.3 Fing the air lter (Fig. 7/8)
• Remove the transportaon stop (B) and screw the air lter (15) to the equipment.