16 17
Assembly Operation
Fitting the extension tubes and tools
1. To t an extension tube (18) to the end of the
exible hose (17), apply the larger opening end
of an extension tube (18) over the end of the
exible hose (17) (Fig M).
2. To add an additional (2 or 3) exible tube/s,
apply the larger opening end of the extension
tube/s (18) over the rst extension tube until
secure (Fig N).
3. For vacuuming, either the oor tool (20), or
crevice tool (21) can be added to the end of the
last extension tube (18) by simply pushing it
onto the extensions tube (Fig O/P)
Dry Vacuuming
WARNING: Users must strictly observe all
warnings and information contained in section
‘General Safety Instructions’ and in section
‘Specic Safety Instructions’ before operating this
appliance.
WARNING: DO NOT use the foam lter (19)
for dry vacuuming applications.
IMPORTANT: The Wet and Dry Vacuum should
only be connected to a mains power supply
socket; an RCD (Residual Current Device) is
recommended.
1. Ensure the tank (10) is completely dry and free
from dust and dirt.
2. Only use the HEPA lter (16) for dry vacuuming
applications (Fig R). Ensure you have already
tted the exible hose (17), extension
tubes (18), and if required, the oor tool
(20) or crevice tool (21) for dry vacuuming
applications.
IMPORTANT: Ensure the HEPA lter is securely
tted before starting the Wet and Dry Vacuum.
3. Plug the power cord (9) into the mains power
outlet and turn on.
4. To commence vacuum mode operation, press
the “I” on the ON/OFF switch (3) (Fig S).
5. To turn o vacuum mode, press the “O” on the
ON/OFF switch (3) (Fig T).
* Dust bags (61406-DB) can also be used for dry
vacuuming and can be purchased separately as
an accessory. Refer to page 25 for details.
On/O switch (Fig Q):
Switch Position 0: OFF (All operations shut o)
Switch Position I: For normal vacuuming
operation (wet or dry)
Switch Position II: Automatic Mode for Power
Tool operation. The vacuum motor will only turn
ON when a power tool, which is plugged into the
AC outlet socket (4) is switched ON. The vacuum
motor will turn OFF when the power tool is switched OFF.
M.
N.
R.
O.
S.
P.
T.
Q.
Operation
To Next Page
Loading...
Need help?
General
