Workzone Titanium+ 51887 - Inserting and Removing Bits; Drill;Driving

24v Lithium-ion Cordless Drill with Hammer Action
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. 51887 • 06/2016 • 51887
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: help@powertoolsupport.com1800 909 909
24v Lithium-ion Cordless Drill with Hammer Action
MODEL: №. 51887 • 06/2016 • 51887
19
Inserting and removing bits
This drill/driver has a keyless chuck, which means
that a chuck (1) key is not needed to secure a bit
in the drill/driver.
Open the chuck (1) by unscrewing it in an
anti-clockwise direction, holding the drill/driver as
shown (Fig H).
Do this sufficiently enough to allow the drill/driver
bit to enter the jaws of the chuck.
Ensure the drill/driver bit is fully inserted, so that the chuck jaws grip the
straight section of the bit.
Rotate the chuck clock-wise until the jaws tighten on the drill/driver bit.
The collar of the chuck needs to be tightened firmly to ensure the drill/driver
bit is held securely.
To remove the drill/driver bit, rotate sharply the chuck in an anti-clockwise
direction, sufficiently enough to allow the drill/driver bit to be removed.
NOTE: This device is fitted with spindle lock and the chuck is a onehanded
operation.
Drill/driving
Drill/driving metals
• Alwaysclampsheetmetal.
• Supportthinmetalwithablockofwoodtoavoiddistortingit.
• Useapunchtomarkthecentreofthehole.
• Useasuitablelubricantforthematerialyouareworkingon,
USE: FOR:
Oil Steel
Turpentine or paraffin Aluminium
Do not lubricate Brass, copper or cast iron
Do not Lubricate Concrete based material
Inserting//Removing bits
H.