Operation
24
3. To set the two line lasers in such a way that they form a laser cross precisely on the
drilling location, lower the drill bit onto the workpiece before start-up.
4. Set the two line lasers with the rotating bezels
27
in such a way that the two line
lasers cross on the workpiece, directly on the supporting surface of the drill bit.
You have now pre-set the line laser for the next time you drill.
If you change the workpiece or use a shorter or longer drill bit, the line laser will need
to be reset.
Drilling workpieces
WARNING!
Risk of injury!
Improper handling may result in severe injury.
− Before you switch the device on, check whether the chuck key has been
removed. The chuck key, if it becomes projectile, may inflict serious injury.
− Keep your hands away from the work area.
− Never attempt to remove drill chips while a drill bit or tool is still rotating.
Always switch the drill off first and wait until it comes to a stop.
− Never remove drill chips with your bare hands as they may have very
sharp edges and may be hot.
− Never touch the drill bit, the tool or the chuck while it is still rotating.
WARNING!
Risk of injury!
When drilling, projectile chips and rotating parts pose a serious risk of injury.
− Wear suitable protective clothing. In particular, protect your eyes by
wearing suitable protective goggles.
− Before working with the device, take off any jewellery (rings, chains etc.).
− If applicable, wear a hair net or cap to prevent your hair from getting
caught in rotating parts.
To Next Page
Loading...
