Troubleshooting
29
Troubleshooting
Problem Possible cause Solution
The drill cannot be
switched on.
The mains plug has not been
inserted in a socket.
− Connect the mains plug
with a properly installed
socket.
The protective hood
1
is not closed and locked in
place.
− Make sue that the protective
hood is closed properly and
locked.
The drill bit /
the tool hardly
penetrates the
workpiece that is
clamped in place.
The drill bit / the tool is not
suitable and/or is not in
good order and condition.
− Use a suitable drill bit / a
suitable tool.
The right speed has not been
selected.
− Set the correct speed.
Technical data
Model: WZ-TB 13 L
Article number: 97015
Operating voltage: 230 V~, 50 Hz
Output: S1 300 W · S2 500 W
Short operation: S2 15 minutes; then the drill has to cool off
Protection class: I
Weight: 16.4 kg
Motor speed: 1450 rpm
Output speed: 300-2410 min
-1
Speeds: 9
Chuck adapter: B 16
Toothed ring drill chuck: 1.5-13 mm
Max. drill depth: 50 mm
Throat depth: 115 mm
Drill column diameter: ∅ 46 mm
Height: 625 mm
Drilling table (W × H): 182 × 170 mm
Base plate (W × H): 314 × 200 mm
To Next Page
Loading...
