Need help?Do you have a question about the Worlde Orca PAD64 and is the answer not in the manual?
Connectors| USB connector | Yes |
|---|
Power| power supply | USB bus power mode |
|---|---|
| current consumption | 100 mA or less |
Weight and Dimensions| dimensions | 256x256x36 mm |
|---|---|
| weight | 840 g |
General introduction to the Orca PAD64 hardware layout and design.
Describes the physical layout and components on the top surface of the Orca PAD64.
Transmit control change messages and act as scene launch buttons in Ableton Live.
Recalls stored parameters and enters setup storing state.
Velocity-sensitive pads for transmitting MIDI notes or control changes.
Switches pads between note mode and triggers, adjusts current note.
Transposes the keyboard by octaves, adjustable range from 0 to 4.
Enables channel or keyboard after touch functions, indicated by LED color.
Selects the current MIDI channel, adjustable from 1 to 16.
Selects velocity response curve (green/red/blue LED).
Toggles mute on/off, no message transmitted in mute mode.
Sets GM Master Volume, sends specific MIDI message.
Used for MMC functions like Stop/Play, works with sequencer software.
Navigates through menus and options.
Connects the Orca PAD64 to a computer via USB.
Outputs MIDI signals to external devices.
Receives MIDI signals from external devices.
Power input interface for the device.
Controls the power state of the Orca PAD64.
Describes the 64 velocity/pressure sensitive RGB backlit pads.
Eight buttons for controlling editable parameters on selected devices.
Switches pads between note mode and triggers, adjusts current note.
Transposes the keyboard by octaves, adjustable range from 0 to 4.
Enables channel or keyboard after touch functions, indicated by LED color.
Selects the current MIDI channel, adjustable from 1 to 16.
Selects velocity response curve (green/red/blue LED).
Toggles mute on/off, no message transmitted in mute mode.
Sets GM Master Volume, sends specific MIDI message.
Used for MMC functions like Stop/Play, works with sequencer software.
Recalls stored parameters and enters setup storing state.
Navigates through menus and options.
Describes the connectors and buttons located on the back panel of the device.
Lists the minimum hardware and OS requirements for Windows and Mac.
Explains the need for the Orca PAD64 control Editor for detailed settings.
Guide to creating custom MIDI presets using the dedicated software editor.
Explains the purpose and capabilities of Orca PAD64 presets.
Configures pads to send MIDI Machine Control commands for song playback.
Assigns pads to trigger specific MIDI note numbers for drum sounds.
Sets a pad to switch a MIDI CC value between two states for effects.
Details how to save current configurations into the device's memory locations.
Explains how to load and switch between saved MIDI presets.
Guide to customizing the RGB color of each of the 64 pads.
Lists toxic or hazardous substances in compliance with SJ/T 11364.
To Next Page
