18
EN
MESSAGE CAUSE ACTION
WRONG PIN! Please
retry.
PIN code is wrong. Input the correct PIN or re-set your PIN.
Blade motor fault!
Press START to
reset.
Blade disc is blocked by an
object, e.g. a branch.
Turn power off.
Turn Landroid Vision upside down and check if there’s anything preven-
ting the blade disc from rotating and remove any obstruction.
Turn Landroid Vision upright.
Turn power on. Press start.
Blade is over-loaded by thick
dense grass.
Turn power off.
Take Landroid Vision to an area with short grass or adjust the cutting
height to a higher setting.
Turn power on. Press start.
Wheels motor fault!
Press START to
reset.
Wheel motor is blocked in
some way.
Turn power off and take Landroid Vision to an area free from obstacles.
Turn power on. Press start.
If the error message is still displayed, turn power off. Turn Landroid
Vision upside-down and check if there’s anything preventing the wheels
from rotating.
Remove any obstruction, turn Landroid Vision upright, turn power on.
Upside down! Press
START to reset.
This could have happened
when Landroid Vision came
into contact with a sloping
surface which made it over-
turn.
Turn Landroid Vision upright and remove any obstacle that might have
caused Landroid Vision to overturn.
Mower trapped!
Press START to
reset.
Landroid Vision is trapped.
Turn power off.
Take Landroid Vision to an area of your lawn free of obstacles, then turn
power on. Press start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down. Check if there is anything preventing the wheels from
rotating.
Remove any obstruction, turn the Landroid Vision upright, turn power
on.
Mower lifted! Press
START to reset.
Landroid Vision has been
lifted up.
Turn power off.
Take Landroid Vision to an area clear of obstacles, turn power on. Press
start.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down and check there’s anything that can cause Landroid Vision
to be lifted up.
Remove any possible object, turn Landroid Vision upright, turn power
on.
Battery voltage too
low! Please change
battery.
Battery exausted, and needs
to be recharged.
In this case you must turn Landroid Vision off and place it in the charging
base, then ‘Emergency charging’ will be displayed and it will start
charging. If the battery error still persist, your battery is damaged and
need to be changed.
Battery temperature
out of range!
Please wait.
Temperature is too high (more
than 45
0
C) or too low (less
than 4
0
C) when charging.
Place the charging base in a shady area or wait until it reaches the nor-
mal temperature.
Can’t find charge
station press START
to reset.
Machine doesn’t have
enough power to go back to
charging base.
Take Landroid Vision to the charging base.
To Next Page
Loading...
