19
EN
MESSAGE CAUSE ACTION
Mower locked!
With the “Lock Function”
enabled, if your Landroid
Vision does not receive a
signal from your Wi-Fi router
for 3 days, then it gets locked
as a security measure.
This could be because
your router lost its power
or because you changed
your Wi-Fi router or network
provider.
Please reconnect Landroid Vision to the Wi-Fi networtk it has been origi-
nally paired with. If this is not possible, contact Cutomer Service.
RFID not found!
RFID is not installed correctly. Check if RFID is correctly installed.
RFID signal is weak. Install the RFID with same number beside the original one.
Camera fault!
Camera covered by dirty
things.
Clean the camera.
NOTES
A. Before turning power on, always check Landroid Vision is inside its working area. If not, the message “Outside working area!
Press START to reset” will be displayed. This message is also displayed when Landroid Vision is partly but not completely inside
its working area.
B. If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging base: press home then
. Landroid Vision will go to its base and stay there. Please note Landroid Vision will now wait until the next scheduled mowing
session. If you want to re-start it at anytime, press then to start your Landroid Vision.
C. If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer to
the installation instructions and check your set up is correct with its help.
D. If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging base: when Landroid Vision runs out of charge, take it manually to the charging base.
E. If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then
restart it. If the problem cannot be solved, please contact our Customer Service for help.
TROUBLESHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM CAUSE SOLUTION
The LED light on the charging
pile does not turn on.
There is no power.
Check the charging base is connected properly to the charger
and the charger is connected to a suitable power supply.
Landroid Vision turns on,
but the blade disc does
not spin.
Landroid Vision is searching for
the charging base.
This is normal: when Landroid Vision needs to recharge, the blade
disc does not rotate while it is searching for the charging base
automatically.
Landroid Vision vibrates.
The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
To Next Page
Loading...
