Worx Landroid S Basic - Page 19

Owner’s Manual of Lawn Mowing Robot EN
19
Landroid
®
runs outside the
boundary wire. Landroid
®
does
not mow an area within a
boundary wire zone. Landroid
®
reverses or rotates erratically
near the boundary wire.
The boundary wire of another Landroid
®
or another robotic mower is positioned
too closely.
Ensure your Landroid
®
Boundary Wire has at
least 1m of space between the neighboring
boundary wire.
The boundary wire has been installed
with tight corners.
Check the boundary wire to ensure the
corners are smooth.
In wet conditions, the boundary wire
electric signal may leak where wire has
been joined or repaired.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
There is boundary wire electric signal
leakage due to broken insulation.
Repair damaged boundary wire insulation
with connectors.
The cutting area is larger than the
allowable cutting area for Landroid
®
.
Contact service agent.
Landroid
®
wheels skid or damage
lawn.
Foreign obstacles, such as twigs
and branches may be lodged under
Landroid
®
.
Remove foreign objects from underside of
Landroid
®
.
The lawn is too wet. Wait until lawn has dried.
Landroid
®
exits the boundary
wire due to high speed when
going down a hill.
The Boundary Wire is placed on a slope
steeper than 17% (10°).
Reposition the Boundary Wire away from
slopes that are steeper than 17% (10°).
Please refer installation manual for details.
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.