A Steelfort Product
steelfort.co.nz
Worx Landroid
Maintenance Sheet
Keep it clean
Your Landroid should be cleaned regularly. This helps keep it in good condition, especially removing
dirt, debris and the build-up of grass from daily mowing. Turn Landroid o before cleaning it. For extra
safety, remove the battery.
WARNING! DO NOT use a hose, high pressure washer or otherwise pour running water on your
Landroid. High pressure water can go inside the sealings and damage electronic and mechanical
parts.
Cleaning the upper body
• Clean with a spray bottle filled with water. Don’t use solvents or polishers
• Use a brush or a clean cloth to remove built-up dirt
Cleaning the bottom
• Flip Landroid upside down
• Remove debris and grass clippings using a brush to remove
• Be careful not to touch the blades with your hands. Wear gloves for protection
• Clean the blade disc, the chassis and the front wheel(s) thoroughly with a soft brush or moist rag
• Rotate the blade disc to ensure it rotates freely. Remove any obstructions. Remove any lodged
debris so that they don’t cause a crack in the blade disk. Even the tiniest crack eects mowing
performance
• Check the blades spin freely around the fixing screws. Remove any obstructions
Cleaning the drive wheels
• Remove mud from wheels with a brush in order to ensure good grip of the tread
Clearing the charging contacts
• Clean the contact pins located on the charging base and the charging strips located on the Landroid
using a cloth
• Periodically remove any build-up of grass clippings or debris around the contact pins and the
charging strips to ensure Landroid successfully charges each time
To Next Page
Loading...
