12
EN
D. Open the rear of Landroid and insert the PowerShare battery into the slot until it clicks (fig.13)
E. Place Landroid on charge by making sure a deep contact is established with the base (fig. 14). The LED will blink green; once the
battery is fully charged, the LED will turn solid green.
F. Let Landroid charge the battery for a while. Whilst it is charging you may want to take a well-deserved break: get familiar with the
following instructions, and connect Landroid to your Wi-Fi network.
7. Close the loop
Once you have completed laying the wire on the perimeter of your lawn, you will arrive back to the charging station.
A. Pass the wire through the guide in the base, up to the clamp (fig.11)
B. Cut the exceeding wire and strip the end with a pair of scissors
C. Insert the stripped end into the black right clamp
8. Final steps
There are only a few more steps to go:
A. Connect the charging station to the AC mains socket (fig. 12)
B. If everything is fine, the LED will light green
C. If there’s a trouble in the loop, such as broken wire or wire ends not properly clamped, the LED will turn red. Check that
everything is fine and see the FAQ session if the problem persists
IN
10
11
11 12
CLICK!
13 14
To Next Page
Loading...
