21
Cordless Grass Line Trimmer & 
Brushcutter, Attachment-Capable  
     EN
STORING YOUR GRASS TRIMMER
Always remove the battery pack from your trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for storing the trimmer on the wall. (See Fig. N)
Store in a dry place where the trimmer and battery can be protected from damage.
MAINTENANCE
Always remove the battery pack from your trimmer after use.
Always check the product prior to being used for any damage.
After use, disconnect the battery from the tool and check for damage.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts in 
your power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. 
Always store your power tool in a dry room temperature location. Keep the motor ventilation slots clean. 
Keep all working controls free of dust.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and battery is 0°C-45°C (32°F-113°F).
The recommended ambient temperature range for the charging system during charging is 0°C-40°C 
(32°F-104°F).
ENVIRONMENTAL PROTECTION 
Waste electrical products must not be disposed of with household waste. Please recycle where facilities 
exist. Check with your local authorities or retailer for recycling advice.
TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate 
correctly.
Warning: Switch the machine off and remove the battery prior to any troubleshooting.
Problems Possible Causes Corrective Action
Trimmer fails to 
operate.
Battery discharged.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine damaged.
Recharge battery; also see 
the content in charger manual.
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Trimmer runs 
intermittently
Motor is broken.
Battery not fully charged.
On/Off switch defective.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Excessive vibrations/
noise.
Machine defective.
Line spool is not wound well.
Contact Service Agent.
Rewind the line. See ’’ To fit spool and 
line assembly.’’
Cutting time per 
battery charge too 
short.
Battery has not been used for long period 
or only charged for short term.
Grass too high.
Battery defective.
Fully charge battery; also see the 
content in charger manual.
Cut in stages.
Replace the battery.