Worx WG209E - PLUG REPLACEMENT (UK & IRELAND)

Hedge trimmer EN
1110
SYMBOLS OPERATING INSTRUCTIONS
WARNING! Do not use the product
without attaching the guard and front
handle.
INTENDED USE
This machine is intended to be used
domestically for cutting and trimming hedges
and bushes.
1. ASSEMBLY OF THE GUARD (See Fig. A)
Insert the Safety Guard(5) into the slot as
illustrated in Fig A.;
Use two screws to fix the guard securely.
making sure it is securely
attached.
2. FRONT HANDLE ASSEMBLY
The Front Handle (4) must be assembled
before use:
1) Attach the Front Handle to the housing.
Make sure the protruding marks on the
Front Handle fit perfectly into the matching
indentation on the housing (See Fig. B & C).
2) Insert and tighten the 4 screws.
3) Check whether handle is firmly secured, if
not retighten the screws.
Make sure the handle is securely
attached in place.
3. MAINS SUPPLY CABLE STRAIN
RELIEF (See Fig. D)
An extension cord retainer is supplied to
reduce strain on the power cord. To use
this feature, form a loop at the end of the
extension cable and bring this through the
opening at the bottom of the Extension
Cord Retainer, then wrap the end of the loop
around the hook and pull to tighten.
4. STARTING AND STOPPING (See Fig. E)
BEFORE STARTING YOUR HEDGE
TRIMMER
Remove Blade Sheath (7).
TO START YOUR HEDGE TRIMMER
There are two switch levers fitted in your
Hedge trimmer (2&3).
Both switch levers need to be depressed for
the product to START. Depress and hold the
Front Switch Lever (3) and press the Rear
To reduce the risk of injury, user
must read instruction manual
Wear eye protection
Wear ear protection
Wear dust mask
Do not expose to moisture
Remove plug from the mains
immediately if the cable is
damaged or cut
Double insulation
Keep hands away
This product has been marked
with a symbol relating to removing
electric and electronic waste. This
means that this product shall not
be discarded with household waste
but that it shall be returned to a
collection system which conforms
to the European Directive 2002/96/
CE. It will then be recycled or
dismantled in order to reduce the
impact on the environment. Electric
and electronic equipment can be
hazardous for the environment and
for human health since they contain
hazardous substances.