to avoid a safety hazard.
Wipe over surface of your Hedge trimmer with
a dry cloth.
WARNING! Never use water for
cleaning your Hedge trimmer. Do not
clean with chemicals,
including petrol, or solvents as this can
damage your hedge trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure your Hedge
trimmer is disconnected from the mains
electricity supply. Apply the oil so that it runs
between the two blades. (See Fig. H)
Your trimmer should be stopped,
disconnected and oiled occasionally during
use.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any
worn or
damaged parts.
TO STORE YOUR HEDGE TRIMMER
Store the hedge trimmer in a secure, dry place
out of the reach of children. Do not place other
objects on top of the machine.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
PLUG REPLACEMENT (ONLY
FOR REWIRABLE PLUG OF
UK & IRELAND)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows. The wire
which is coloured blue must be connected to
the terminal which is marked with N. The wire
which is coloured brown must be connected
to the terminal which is marked with L.
WARNING! Never connect live or
neutral wires to the earth terminal of the
plug. Only fit an approved BS1363/A plug and
the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
To Next Page
Loading...
Need help?
General
