EasyManuals Logo

Worx WG209E User Manual

Worx WG209E
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
8
Hedge Trimmer WG209E WG210E
A
C
E
F
G
H
D
B
a
4. HOW TO USE YOUR HEDGE TRIMMER
Inspect the area to be cut before each use, remove
objects which can be thrown or become entangled in
the cutting blades.
Always hold the Hedge trimmer with both hands and
with the blade away from you before turning it on.
Always keep the power cord behind the Hedge
trimmer when in use. Do not place it over the
hedge that you are trimming where it may be cut
by the blade.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the blade.
Allow the cutting blades to reach full speed before
entering the material to be cut.
Always work going away from people and solid objects
such as walls, large stones, trees, vehicles etc.
If the blade stalls, immediately stop the Hedge trimmer.
Disconnect the Hedge trimmer from the mains and clear
the jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Move the Hedge trimmer to feed the branches directly
into the blade cutting edges.
Do not try to cut stems that are too large to feed into the
cutting blade.
TOP CUTTING (See Fig. F)
Use a wide sweeping motion. A slight downward tilt of
the cutting blades in the direction of motion gives the
best cutting results.
SIDE CUTTING (See Fig. G)
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth.
WARNING: Check extension cords before each
use. If damaged replace immediately. Never use
your tool with a damaged cord since touching the
damaged area could cause electrical shock resulting in
serious injury.
If the supply cord is damaged, it should be replaced by
a local approved Service Centre.
Take care not to expose this tool to rain.
MAINTENANCE
CLEANING
Disconnect from mains electrics supply. Using a soft
brush-remove debris from all air intakes and cutting
blade.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order

Other manuals for Worx WG209E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Worx WG209E and is the answer not in the manual?

Worx WG209E Specifications

General IconGeneral
BrandWorx
ModelWG209E
CategoryTrimmer
LanguageEnglish

Related product manuals