Worx WG500E - Page 8

All-in-one blower/vac/mulcher WG500E WG501E


I
K
J
L
itinsideoutandshakeoutanyexcessdebris.Oncea
year, hand wash the bag in soapy water and allow it to
air dry.
WARNING: Normalusageofthebagcauses
it to wear and deteriorate over time. A worn or
deteriorated bag allows small objects to be thrown
through the bag, possibly injuring the operator or
bystanders. Check the bag frequently. If it is worn or
deteriorated, replace it with a vacuum bag.
REMOVING CLOGGED DEBRIS FROM THE
IMPELLER
1. Turn off and unplug the vacuum from the power
source and wait for all moving parts to stop.
2. Movetheon/offswitch(2)to‘’0’’positionrstly,and
then press the release button (3), so that you can
separate the tube.(Fig K)
3. Then you can remove the debris as shown in Fig L.
4. Check the impeller for any signs of damage. If it is
damaged, contact your Authorized Dealer.
5. Install the Blower/Vacuum Tube.
STORAGE
Storetheblower/vacuumandextensioncordindoors,
in a cool dry location, out of reach of children and
animals.