8
High pressure cleaner WG600E WG601E WG602E
4. PRESSURE HOSE AND TRIGGER GUN
ASSEMBLY (See Fig. E1, E2, F)
1) To attach the pressure hose to the cleaner locate the
connecting port on the back of the cleaner between
the wheels.
Press the latch towards the hole and insert the metal
connector of the high pressure hose (See Fig. E1).
Release the latch to lock the hose in place.
An alternative method of hose insertion is to firmly
press the hose connector into the connecting port
without pressing the latch until it clicks into place
securing it.
After the hose is attached, check the connection by
gently pulling upon the hose. It should not pull out.
2) To attach the pressure hose to the trigger gun, locate
a latch and connecting port in front of the trigger.
Press the latch towards the trigger and insert the
hose connector (See Fig. E2).
Confirm the connection by gently pulling upon the
hose. It should not pull out
3) When not in use the trigger gun may be stored in
the snap on accessory latch (See Fig. F).
ATTACHMENT OF ACCESSORIES
Illustration Description Application
Lance
Connection to be
used with nozzles
Rotor (turbo)
nozzle
(WG601E
WG602E
only).
Turbo spray. High
pressure direct
spray for cleaning.
used in conjunction
with lance.
Fixed spray
nozzle.
Flat spray. High
pressure spray for
general cleaning
applications. used
in conjunction with
lance.
High
pressure
foam
nozzle.
Provides detergent
suds for deeper
cleaning of dirt.
Used in conjunction
with fixed spray
nozzle and lance.
To Next Page
Loading...
Need help?
General
