Cordless lawn mower EN
1110
INTENDED USE
This product is intended for domestic lawn
mowing.
ASSEMBLY
IMPORTANT! Before you assemble
the lawn mower, check the accessories
according above information, make sure the
accessories are completed.
1. FITTING THE HANDLE (See Fig. A1- A5)
1) Remove the screws (a) on the both side of
deck. (See Fig. A1)
2) Insert the Lower Handle Bar into the holes
on the deck. Be sure to carefully align the
screw holes found on the Lower Handles
with the screws holes found on the deck
(a). (See Fig. A1 A2)
3) Secure the Lower Handle Bars to the deck
with the screws provided (See Fig A2) .
4) Attach the Middle Handle (9) to the Lower
Handle with the Handle Knobs Assembly
(8). After this is complete, attach the Upper
Handle (1) to the Middle Handle with the
upper Handle Knobs (7) (See Fig. A3).
5) Tightening the two Handle Knobs. Check
that the handle is FULLY secured.
The cam lever pressure can be adjusted
by rotating the upper or the lower Handle
Knobs clockwise/counterclockwise (See Fig.
A4). DO NOT OVER TIGHTEN.
NOTE: Ensure that the bolts are fully
inserted through the handles before
adjusting or tightening the Handle Knobs.
6) First, insert the cable into the Cable Clips
(3) provided ensuring there is enough slack
cable to allow the handlebars to collapse
for storage. After inserting the cable, attach
the Cable Clips to the Upper and Middle
Handle bars (See Fig. A5)
NOTE: Make sure the cable is routed
underneath the Middle Handle Bar
(See Fig.A5).
2. GRASS COLLECTION BAG ASSEMBLY
Connect the grass box handle to the box top
as shown in Fig B1-B4.
Step 1. Press the front of the handle briefly.
(See Fig. B2)
Step 2. Then push it forward. (See Fig. B2)
Step 3. Push down the back of the handle.
(See Fig. B2)
Step 4. Finally, clip the plastic clips over the
metal frame. (See Fig. B3)
WARNING: Don’t fit the handle in
reversed direction. Fit the handle as
shown in Fig B1.
3. GRASS COLLECTION BAG FITTING
(See Fig. C1, C2, C3)
1) Turn the mower off, wait until blade stops
and remove safety key (6).
2) Pick up the grass collection bag by the
handle, and position grass collection bag
on the lower hooks (b) on the mower deck
(See Fig.C2).
3) Release the safety guard to lock the
grass bag into position. Ensure the grass
collection bag is installed securely
(See Fig. C3).
NOTE: Depress the grass collection bag
slightly to ensure that it is completely
installed.
4. REMOVING/EMPTYING
Hold the grass collection bag, lift the safety
flap (10) and hold up. Remove grass collection
bag (4).
WARNING! Always check the safety
flap can close the discharge outlet
tightly before using. Never lift the safety flap
(10) when the lawn mower is being used
without fitted grass collection bag.
5. FITTING/REMOVING BATTERY
(See Fig. D1, D2)
Depress the battery release button to release
battery pack from your mower (See Fig. D1).
After recharging, insert the battery pack into
mower’s battery port (See Fig. D2). A simple
push and slight pressure will be sufficient.
NOTE: When removing the battery pack, hold
it firmly to avoid dropping and injury.
To Next Page
Loading...
