11
OPERATING INSTRUCTIONS
Note: Before using the tool, read the
instruction book carefully.
INTENDED USE:
This tool is intended for the fastening and
loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use as a
drill.
ASSEMBLY AND OPERATION
Action Figure
Before operation
Checking the battery
charge condiction
See Fig. A1
Removing The Battery
Pack
See Fig. A2
Charging The Battery See Fig. A3
Installing The Battery
Pack
See Fig. A4
Assembly
Inserting and Removing
Bits and Socket
See Fig. B1, B2
Assembling the belt
hook and bit clip
See Fig. C1, C2,
C3, C4
Operaton
Switch Lock See Fig. D1
Forward And Reverse
Rotation Control
Warning: Never
Change The Direction
Of Rotation When The
Chuck Is Rotating, Wait
Until It Has Stopped!
See Fig. D2, D3
Variable Speed Control
See Fig. E
Operating the On/Off
Switch
Warning: Do not
operate for long
periods at low speed
because excess heat
will be produced
internally.
See Fig. F
Using The Sight Light
Before operation, the
LED light will be activated
when the On/Off switch is
slightly depressed, and will
automatically turn off 20
seconds after the On/Off
switch is released.
The tool and battery are
equipped with a protection
system. When the LED Light
is quickly flashing 3 seconds
and turn off, the system will
automatically cut off power to
the tool to extend battery life.
The tool will automatically stop
during operation if the tool and/
or battery are placed under one
of the following conditions:
• Overloaded: The tool
is operated in a manner
that causes it to draw an
abnormally high current. In this
situation, release the Trigger
Switch on the tool and stop the
application that caused the tool
to become overloaded. Then
pull the Trigger Switch again to
restart.
• Overheated: Under the
condition above, if the tool
does not start, the Tool and
Battery are overheated. In
this situation, let the Tool and
Battery cool before pulling the
Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity
is too low and the tool will
not operate. In this situation,
remove and recharge the
Battery.
Warning: To turn on the
light, press the On/Off switch
and make sure the Forward/
Reverse Rotation Control is on
right/left position.
See Fig. F
To Next Page
Loading...
