Worx WU334 User Manual

11
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.
Warning!
Never connect live
or neutral wires to
the earth terminal
of the plug. Only
fit an approved
13A BS1363/A
plug and the
correct rated fuse.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
Cable grip
Brown L (live)
13 Amp fuse approved
to BS1362
Plug replacement
(UK & Ireland only)
If you need to replace the fitted plug then follow the instructions
below.
IMPORTANT
The wires in the mains lead are colored in accordance with the
following code:
BLUE =NEUTRAL BROWN = LIVE
As the colors of the wires in the mains lead of this appliance may not
correspond with the colored markings identifying the terminals in
your plug, proceed as follows. The wire which is colored blue must
be connected to the terminal which is marked with N. The wire which
is colored brown must be connected to the terminal which is marked
with L.
Note: If a moulded plug is fitted and has to be removed take great
care in disposing of the plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Symptom Possible Cause Remedy
Machine fails to
operate
No power supply to
machine
Turn power on
Use another socket
The power
and hammer
efficiency of the
machine is low.
Machine may be cold
Warm up the machine
for 1-2 minutes until it
reaches a proper working
temperature
Your drill bit does not slide
freely in the chuck
Clean the dust and debris
inside the chuck; Grease
the shank of the bit if
necessary.
Your drill bit will
not fit into the
chuck easily
The chuck is dirty with
dust and debris.
Clean the dust and debris
from inside the chuck
The shank of the bit is
damaged or distorted
Change a new bit
A drill bit has broken and
the shank has remained
in the chuck
Remove the chuck, and
take out the bit as shown in
Fig.H, then clean the chuck
inside.
You cannot
remove your drill
bit from the chuck
The shank of the bit is
damaged or distorted;
The chuck is dirty with
dust and debris.
Remove the chuck, and
take out the bit as shown in
Fig.H, then clean the chuck
inside.

Worx WU334 Specifications

General

Brand	Worx
Model	WU334
Category	Rotary Hammer
Language	English