To Next PageTo Next Page
Need help?Do you have a question about the Worx WX333 and is the answer not in the manual?
General| Drilling | Yes |
|---|---|
| Chuck type | SDS Plus |
| Motor type | Brushed |
| Screwdriving | - |
| Product design | Pistol grip drill |
| Idle speed (max) | 750 RPM |
| Chuck capacity (max) | - mm |
| Impact rate (high speed) | 3700 bpm |
| Drilling diameter in wood (max) | 40 mm |
| Drilling diameter in steel (max) | 13 mm |
| Drilling diameter in concrete (max) | 32 mm |
| Product color | Black, Orange, White |
| Cable length | 2.8 m |
| Output power | 1250 W |
| Power source | AC |
| AC input voltage | 220 V |
| Impact energy (max) | 5 J |
Weight and Dimensions| Depth | 180 mm |
|---|---|
| Width | 490 mm |
| Height | 350 mm |
| Weight | 6100 g |
Wear ear protection to prevent hearing loss from noise exposure.
Use auxiliary handle for better control and to prevent personal injury.
Always wear a dust mask during operation.
Hold tool by insulated surfaces to avoid electric shock from hidden wiring.
Connect mains plug only when the tool is switched off.
Direct the cable away from the machine during use.
Persons under 16 years of age are not permitted to operate this machine.
Keep tool and accessories out of children's reach.
Disconnect the plug before performing adjustments, servicing, or maintenance.
Fully unwind extension cables to prevent overheating.
Ensure extension cables have correct ampere rating and are safe.
Ensure mains supply voltage matches the tool's rating plate voltage.
Tool is double insulated for enhanced electrical protection.
Check walls and ceilings for hidden cables and pipes before drilling.
External metal parts may be hot after prolonged use.
Wear eye protection when operating the tool.
Use auxiliary handles and proper grip to maintain control and prevent injury.
Explanation of symbols used in the manual for safe operation.
Details the machine's purpose for hammer drilling and light chiseling.
Instructions on how to adjust the auxiliary handle for safe operation.
Guide on setting the depth gauge for consistent drilling depth.
Procedure for installing SDS bits or a 3-jaw chuck securely.
Steps to safely remove bits or the chuck from the tool holder.
Information on using the 3-jaw chuck for non-SDS bits.
Instructions on how to start and stop the tool using the switch.
Explanation of how to adjust the tool's speed.
Steps to engage the hammer drill mode for concrete and masonry.
Steps to engage the drilling mode for standard drilling operations.
Instructions for using the chisel mode for chipping and demolition.
How to attach and use the dust cover for overhead drilling.
Guidance on lubricating the machine for optimal hammer work efficiency.
Procedure for inspecting and replacing carbon brushes.
Tips for reducing pressure, drilling large holes, and applying force correctly.
Instructions on cleaning, storing, and servicing the power tool.
Solutions for the tool not starting or overheating, and low efficiency.
Guidance on proper disposal of waste electrical products.
Instructions for replacing the fitted plug, including wiring details.
Manufacturer's declaration of compliance with EU directives and standards.
