Worx WX333 User Manual

Rotary hammer EN
9
8
ADDITIONAL SAFETY
POINTS FOR YOUR
ROTARY HAMMER
1. Wear ear protectors. Exposure to noise
can cause hearing loss.
2. Use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
3. Always wear a dust mask.
4. Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden wiring
or its own cord. Cutting accessory
contacting a “live” wire may make
exposed metal parts of the power tool
“live” and could give the operator an
electric shock.
5. Connect the mains plug only when the tool
is switched off. After using, pull the mains
plug.
6. Always direct the cable to the rear away
from the machine.
7. Persons under 16 years of age are not
permitted to operate this machine.
8. Keep the tool and accessories out of the
reach of children.
9. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
10. Fully unwind cable drum extensions to
avoid potential over heating.
11. When an extension cable is required you
must ensure it has the correct ampere
rating for your power tool and that it is in
a safe electrical condition.
12. Ensure your mains supply voltage is the
same as your tool rating plate voltage.
13. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
14. Always check walls and ceilings to avoid
hidden power cables and pipes.
15. After long working periods, external metal
parts and accessories could be hot.
16. Wear eye protection when operating this
tool.
17. Your hand must hold on the handle when
you are working. Always use the auxiliary
handles supplied with the tool. Loss of
control can cause personal injury.
TORQUE LIMITER
There is a clutch in your rotary hammer.
The torque limiter will actuate when a certain
torque level is reached. The motor will
disengage from the output shaft. When this
happens, the bit will stop turning.
As soon as the torque limiter actuates, switch
off the tool immediately. This will help prevent
premature wear of the tool.

Worx WX333 Specifications

General

Drilling	Yes
Chuck type	SDS Plus
Motor type	Brushed
Screwdriving	-
Product design	Pistol grip drill
Idle speed (max)	750 RPM
Chuck capacity (max)	- mm
Impact rate (high speed)	3700 bpm
Drilling diameter in wood (max)	40 mm
Drilling diameter in steel (max)	13 mm
Drilling diameter in concrete (max)	32 mm
Product color	Black, Orange, White
Cable length	2.8 m
Output power	1250 W
Power source	AC
AC input voltage	220 V
Impact energy (max)	5 J

Weight and Dimensions

Depth	180 mm
Width	490 mm
Height	350 mm
Weight	6100 g