Charger. Disconnect the Charger from the screwdriver. The
screwdriver is ready to be used.
IMPORTANT:
When charging, the Charger and screwdriver may become
warm to the touch; this is normal and does not indicate a
problem.
2. OPERATING INSTRUCTIONS
Inspect the screwdriver before using to ensure all the parts are
running smoothly and there are no abnormal sounds or sparks.
Before driving fasteners, check behind walls for wires and other
electrical hazards or plumbing.
OPERATION
1. INSERTING THE BIT CARTRIDGE (See Fig. B)
Pull the Cover (1) back completely to insert the Bit Cartridge (7).
2. SELECTING A BIT
1. Slide the Cover fully open, past the red line on the tool. The
Bit Cartridge will advance automatically. (The Bit Cartridge
can be manually rotated to left direction if preferred.)
(See Fig. C1, C2).
B
C1
To Next Page
Loading...
Need help?
General
