16
TROUBLE SHOOTING
Problem Possible cause Solution
Battery will not charge 1. Charger not plugged into a
working outlet.
2. Surrounding air temperature
is too hot or too cold.
1. Plug charger into a working outlet. Check cur-
rent by plugging in a lamp.
2. Move charger to an appropriate place which
temperature is suitable for the charger.
Switch cannot be pressed Forward/Reverse switch at
middle position
Make sure switch is on Forward or Reverse rota-
tion according to project need.
Driver stops during driving
screws
Driver battery is out of power Make sure the driver is fully charged before
using it.
Bit Cartridge will not rotate
when Cover slides.
The cover is not fully open Make sure the Cover is fully open and past the
red line on the tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
To Next Page
Loading...
Need help?
General
