Worx WX255L - OPERATING INSTRUCTIONS; Before Operation and Assembly; Tool Operation

18
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ACTION FIGURE
BEFORE OPERATION
Charging the Battery
NOTE: 1. Maximize Battery Performance
Prior to initial use, the battery must be charged 5 hours to fully utilize the battery capacity.
2. When the battery is full charged, the light turns green.
See Fig. A
ASSEMBLY AND ADJUSTMENT
Inserting and Removing the Bit Cartridge
See Fig. B,C
Assembling and Removing the Screw Holder
See Fig. D1,D2
INSTALLING AND REMOVING EXTENDABLE FLEXIBLE SHAFT (ONLY FOR
WX255L.2 )
See Fig. E1,E2
Forward/Reverse/Lock
WARNING: Never change the direction of rotation when the chuck is rotating, wait until
it is stopped!
See Fig. F1,F2,F3
OPERATION
Selecting a Bit See Fig. G1, G2
Assembling screw
See Fig. H1,
H2, H3
Tightening and Loosening Screw See Fig. I1, I2
Operating the On/Off Switch
WARNING: Do not operate for long periods at low speed because excess heat will be
produced internally.
See Fig. J
LED Light Indicator See Fig. J