Cordless rotary hammer
WX382 WX382.1
WX382.2 WX382.3
13
condition. Where possible use a pilot hole
before drilling a large diameter hole.
PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, having not used a
battery pack for a prolonged time will reduce
the battery pack working time. This can be
corrected after several charge and discharge
operations by charging & working with
your tool. Heavy working conditions such
as large screws into hard wood will use up
the battery pack energy faster than lighter
working conditions. Do not re-charge your
battery pack below 0
o
C and above 30
o
C as
this will affect performance.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance, except for the
cleaning & lubrication of the SDS bits and
adaptors before inserting into the chuck.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working
controls free of dust. Occasionally you may
see sparks through the ventilation slots. This
is normal and will not damage your power
tool.
DISPOSAL OF AN
EXHAUSTED BATTERY
PACK
To preserve natural resources, please
recycle or dispose of the battery
pack properly. This battery pack
contains Li-ion batteries. Consult your local
waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating
your tool, then remove the battery pack
from the tool housing and cover the battery
pack connections with heavy-duty adhesive
tape to prevent short circuit and energy
discharge. Do not attempt to open or remove
any of the components.
To Next Page
Loading...
