Worx WX800 - Working Hints for Your Angle Grinder

12
Lithium-Ion cordless angle grinder EN
ACCESSORIES
WX800 WX800.1 WX800.9
Metal grinding disc 1 1 1
Wheel guard for
grinding
1 1 1
Spanner 1 1 1
Auxiliary handle 1 1 1
2.0Ah
Battery(WA3551.1)
2 1 /
1Hr Charger
(WA3880)
1 1 /
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
ASSEMBLY AND OPERATION
Action Figure
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack
WARNING: When
replacing the battery
pack, do not insert the battery
until the Grinding/Cutting Disc
comes to a complete stop!
See Fig. A3
ASSEMBLY
Assembling Auxiliary Handle See Fig. B
Assembling Grinding/Cutting Disc
See Fig. C1,
C2, C3
Adjusting Wheel Guard
Note: Before any work on the
machine itself, remove the
battery pack. For work with
grinding or cutting discs,
the protection guard must
be mounted. Use the correct
type of disc for your appli-
cation. If the power tool is
intended to perform cutting
off operations, a guard spe-
cific for this operation must
be fitted.
The coded projection on the
wheel guard ensures that only a
guard that fits the machine type
can be mounted.
Open the clamping lever (13).
Place the wheel guard with coded
projection into the coded groove
on the spindle of the machine
head and rotate to the required
position (working position).
To fasten the wheel guard, close
the clamping lever (13).
The closed side of the wheel
guard must always point to
the operator.
See Fig. D
OPERATION
Using On/Off Switch See Fig. E
Hand Grip Areas See Fig. F
Rough Grinding
WARNING! Never use a
cutting disc for roughing.
Cutting See Fig. G
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve maximum
speed then start working.
2. Do not force the disc to work faster, reducing the
Disc’s moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the
cutting angle otherwise you will stall the disc
and angle grinder motor or break the disc. When
cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of
the cut slot.
5. When cutting very hard material best results can
be achieved with a diamond disc.