Worx WX840 - User Manual

Questions and Answers

G
Gregory WadeAug 12, 2025
What to do if my Worx Staple Gun is not working properly?
- R
  Raymond MarquezAug 12, 2025
  If your Worx Staple Gun isn't operating correctly and you see a green light flashing, a red light flashing, or both, here's what you can check: * The tool may be overheating, so wait until it cools down. * Ensure that the tool has enough nails and replenish them if necessary. * Check for jammed nails and remove them. * The battery might be low, so recharge it.
C
Christopher GonzalezAug 20, 2025
What to do if fasteners don't drive fully with my Worx Staple Gun?
- G
  Gary RodriguezAug 20, 2025
  If your Worx Staple Gun operates properly, but fasteners don’t drive fully, it could be due to the following: * The depth of drive isn’t deep enough; adjust the depth of drive. * The nail might be too long for the wood hardness; use a nail length that is appropriate for the wood.
K
Kristy MillerAug 27, 2025
Why does my Worx Staple Gun jam frequently?
- D
  Diane HolderAug 27, 2025
  If your Worx Staple Gun is jamming frequently, consider the following: 1. Make sure you are using the correct size of nails. 2. Replace any damaged nails. 3. Ensure the magazine is not loose by tightening the screws. 4. Clean the magazine, as a dirty magazine may cause jams.
B
Briana KaneSep 3, 2025
How to prevent fasteners from being driven too deep with my Worx Staple Gun?
- A
  Alexis CooperSep 3, 2025
  If your Worx Staple Gun is driving fasteners too deep, the depth of drive may be set too deep. Adjust the depth of drive accordingly.