12
20V Cordless 18 gauge Nail/Staple Gun
EN
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
Tool does not operate properly:
green light flashing
green light on
red light flashing
red light on
Tool is overheat
No nails
Jammed nails
Low battery
Wait until the tool cools down
Replenish nails
Removing a jammed nail
Recharge battery
Tool operates properly, but
fasteners do not drive fully
Depth of drive isn’t deep
enough
Nail is too long for wood
hardness
Adjust depth of drive
Use nail length that is appropriate for
wood
Tool operates properly, but
fasteners are driven too deep
Depth of drive is too deep Adjust depth of drive
Tool jams frequently Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for recycling advice.
To Next Page
Loading...
Need help?
General
