10
20V Cordless 18 gauge Nail/Staple Gun
EN
Nail length
Brad nail 20mm - 50mm
Crown staple 20mm - 40mm
Machine weight
3.2kg 2.9kg
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure L
pA
= 77.5dB(A)
A weighted sound power L
wA
= 88.5dB(A)
K
pA
&K
wA
3dB(A)
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration
emission value:
a
h
= 3.633m/s
2
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX840 WX840.1 WX840.2
WX840.9
Battery pack
1 (WA3551.1) 2 (WA3551.1)
1 (WA3553) /
Charger
(WA3880)
1 1 1 /
38mm Brad
nails (200pcs)
1 1 1 1
32mm Crown
staples (200pcs)
1 1 1 1
Allen key
1 1 1 1
Belt hook
1 1 1 1
Screw
1 1 1 1
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This tool is intended for nailing decoration of board
line, skirting line and wooden frame, etc.
WARNING: Do not point the nail gun to
people or animals. Always remove the
nails and the battery pack when not using the
tool.
ASSEMBLY AND OPERATION
ACTION FIGURE
BEFORE OPERATION
Removing the battery pack See Fig. A1
Charging the battery pack See Fig. A2
Installing the battery pack See Fig. A3
To Next Page
Loading...
