DRINK10 Distiller Operation Manual
REV-A Page 7 of 26
3.3 Working Environment
Distiller installation should be left at least 10cm all around, and 20cm to the top.
Advise installing in an environment with good condition of ventilation.
Ambient temperature:0-30℃.
Relative humidity: ≤80%
Air-pressure: 860Hpa～1060Hpa
Earthing
3.4 Installation
Set the distiller on a stable surface, and keep at least 10cm from graphic edge.
For safety, please remove all stuff from distiller.
For convenient operation, please remove all stuff in front of distiller.
Do not set bottle with rusty liquid around distiller, for eliminating potential hazard while
Thermal distillation.
3.5 Power Connector
Check the nameplate under distiller bottom whether it corresponds relevant supply
voltage or not.
The provided cable location is in the bottom side.
Do not split or fold power cord for avoiding power cord damage!
Do not put any heavy stuff on the power cord for avoiding power cord
damage!
Do not use other power cord for avoiding Electrical components damage!
Do not use lengthened power cord for avoiding current leakage!
To Next Page
Loading...