Wozniak RC Tech KLW202 - Getting started; Making connections

4. Getting started
4.1. Making connections
● The current is measured by BLACK cable, current flow from -ESC to -BATT cable.
Connect this cable between battery negative and ESC negative terminal.
● The voltage is measured by RED +BATT cable. In the absence of ESC power (the kill
switch is disconnected) , this cable provides a backup power to maintain the memory
of the amount of energy consumed. Connect this cable to battery positive terminal, you
may use balancer connector.
● The device is power supplied from ESC, supply voltage 4,5 – 6 V. Ground of ESC
cable is not connected to -ESC cable (ground of the limiter) inside the device, be
sure to allways connect -ESC cable to the ESC.
● The device measure the energy consumption of the connected load and itself.
● Do not leave the device connected to the battery unattended. Long-term connection to
the battery can lead to excessive discharge and its destruction.
ATTENTION:
When connecting, pay special attention to the polarity. Black or brown wire - Negative pole (-)
Red wire - Positive pole (+). Yellow wire – PWM Signal.
5
- BATT
+BATT
- ESC
BATTERY
BLACK
RED
ELECTRONIC
SPEED
CONTROL
(ESC)
MOTOR
RECEIVER
SERVO
SERVO
REC
ESC
KILL SWITCH