6. Limiter
Limiter counts energy when current is greater than set in Starting current threshold, so
you can skip energy counting while the model is being prepared for start. Limiter after reach the
programmed limit of energy reduce the throttle demand to the ESC. The parameters of the reduction
are programmable. Figure below explains them.
In order to resrt the energy value, the device should be completely disconnected from
the power supply (both from the ESC cable side, eg by pulling out the kill switch and the red cable
+ BATT measuring the battery voltage) and wait 1 - 2 minutes. This process should be carried out
before each new start, so that the energy value is counted from 0. When the power supply is
connected, the value of the last energy value blinks on the display for 4 seconds, it does not affect
the new measurement.
The device to determine the value of percent energy reduction need to know minimum
and maximum pulse width of signal controling ESC. The maximum pulse width (maximum power)
is determined automaticly as a maximum pulse width since turn on the device. The minimum pulse
width could be determined automaticlly or set manually by menu option t
PWM
. To select the
automatic mode set "---", the pulse width will be measured with KLW202 turn on. The transmitter
must be switched on in advance and the throttle set to minimum. To select the manual mode, enter
the pulse width value in 10*us. For example to set 1 ms enter value 100.
7
To Next Page
Loading...