EasyManua.ls Logo

WP XACT PRO 7448 - Page 18

WP XACT PRO 7448
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 TUNING THE CHASSIS
16
Info
Check or adjust the air pressure under the same conditions at the earliest 5 minutes after switching off
the engine.
The air suspension is located in the left fork leg. The rebound and compression damping is located in
the right fork leg.
When changing the air pressure, always observe the correct value of the visible inner tube length and
only proceed in small steps.
First set the positive chamber, then the negative chamber and finally the positive chamber again.
Preparatory work
Raise the motorcycle with a lift stand. ( p. 11)
M01748-10
Main work
Remove valve cap
1
.
Push together fork airpump
2
fully.
Fork airpump (79412966100)
Info
The fork airpump is included.
Mount adapter
3
on the fork airpump.
Adapter (T14086E)
Info
The adapter is included.
The adapter is connected to the valve.
Rotate the upper part of the adapter clockwise.
The interior valve opens.
The fork airpump switches on automatically.
A little air escapes from the fork leg when connecting.
Info
This is due to the volume of the hose and not due to a
defect in the fork airpump or the fork.
Read the accompanying instructions.
Adjust the air pressure as specified.

Related product manuals