Wulftec WRTA-150 - Troubleshooting WRTA 150; Machine Stops and Indicator Light Issues

Wulftec / M.J. Maillis Group Page 36 of 36 Version 1.7.1 /November 2014
Problems Causes Solutions
Power light is
not on
• Main fuse is OFF.
• Light bulb may be burned out.
• Main switch is in the off position
• Main fuses are burned.
• Related glass fuse is burned.
• Turn on the main fuse.
• Change the light bulb.
• Turn the switch to the on position.
• Check for short, if none change the
main fuse using the right rating.
• Check for short, if none change the fuse
using the right rating.
Start (blue)
light does not
come on after
pushing on
start.
• Light bulb may be burned out.
• An alarm might be activated.
• One of the automatic modes was not
engaged. (Wrapping or passthrough.)
• Change the light bulb.
• Accept the alarm.
• Make sure that the machine is in
automatic mode and that a reset was
done.
If you cannot find a solution to your problem with this guide, please contact your distributor.