WUNDER ASEP-6 - Page 10

WUNDER SA.BI.SRL USER MANUAL
ASEP-ASEP-P INOX REV.01 15/12/2016 10
amount
c. Press =
d. The PAID INDICATOR goes off and the CHANGE INDICATOR appears to indicate the value shown on the UNIT PRICE
panel is the amount to be changed
e. All transactions stored in memory are now erased, display will return to normal after 5 seconds
5.11 UNIT PRICE LOOKUP (PLU)
This unit is equipped with 5 direct and 94 internal PLUs (unit price lookups). Follow the below procedures for how to use
the PLU function.
5.11.1 To Store a Unit Price to PLU
a. By making use of the numeric and decimal keys to enter the unit price
b. Press PLU SET, TOTAL PRICE panel shows “PLU.=?”
c. Press any one of the 5 direct PLUs or use the numeric keypad to enter any location from 06 to 99 to store the unit
price
d. TOTAL PRICE panel will show “##_PL”, which ## denotes the location that is designated by the user. Scale will return
to normal after 1 second
5.11.2 To Recall the Unit Price from PLU
Unit prices stored in location 01 to 05 can be recalled by pressing the direct PLU keys. Unit price stored in location 06 to
99 can be recalled by the:
a. Press PLU RECALL and TOTAL PRICE panel shows “PLU.=?”
b. Enter the two digits PLU location
c. The information stored in that PLU will show on the UNIT PRICE panel
5.11.3 To Clear Unit Price from PLU
A unit price stored in PLU location can be erased by entering a zero or new unit price.
5.12 BACKLIGHT (OPTIONAL ACCESSORIES) SETTINGS
Follow the below steps to turn on and off the backlight.
5.12.1 Turn Backlight On: - Power Saving Mode
Press 1 and then press ON/ZERO to enable backlight in power saving mode. Under this mode, backlight will goes off
after scale has been left idle for 20 seconds.
Backlight will automatically turn on again when a new weight is detected or when a key is pressed.