Wurkkos TS21 - Page 7

UI:ElectronicLockout
LockoutmodepreventsaccidentalTS21activation.Lockoutmodealsodoublesasamomentarydimlight,so
theusercandoquicktaskswithouthavingtounlocktheflashlight.ItusestheFLOORofthecurrentramping
modeasthelightlevel.Withclick,holdyoucanusetheFLOORoftheotherrampingmode.
ElectronicLockoutenable: 4 clicks from OFF to enable the electronic lockout. OperationinElectronic
LockoutislimitedtoholdingthebuttontoturnonTS21at thefloorofthelastramprangeused(either
smoothorstepped).
ElectronicLockoutdisable: 4clicksfromOFFtodisabletheelectroniclockout.
Blinkies&Strobes
Twogroupsofblinkiesareincluded.Toenterthem,doeithera3clicks(3C)fromOFFora“2clicksandhold”
(3H)fromOFF.Tochangetothenextblinkymodedouble‐click.Theseinclude:
Group1Blinkies/utilitymodes:
(alwaysstartsfromBattCheck)fromOFF:3clicks.
 BattCheck:
Showstheremainingchargeinvoltsandtenths,e.g.4blinks,thenpause,1blinkare4.1Volt.A"zero"is
representedbyaveryquickblink.ItisrecommendedthatiftheBattCheckrevealsthecellvoltageat3.1Volt
orlower,itistimetorechargethebatteries.ToexitBattCheckeitheroneclickforoff,ortwoclicksforSunset
/Goodnightmode.
 Sunset/Goodnightmode:
Startsatalowlevel,thenslowlydimsdowntomoonoverthecourseofanhour,thenshutsoff.Itisintended
forusewhengoingtobed.ToexitSunset/Goodnightmode,oneclickforoff,twoclicksforBeacon.
 Beacon:
Beaconmodeusesthelastrampedlevelforitsbrightness.Youmustadjustthebrightnessbeforeyouturn
beaconon.Itblinksataslowspeed:OnceeveryNsecondsatthelast‐rampedlevel.
Nisconfigurableinbeaconconfigmode:Click4timestoenterbeaconconfigmode.TS21willflashonce,
thenthelightoutputwillflickerforabout3seconds.Duringtheflicker,clicktoenterthenumberofseconds
perblink.Forexample,todoa10‐secondalpinebeacon,click10times.TS21willkeepflickeringuntilthe
userstopsclicking,sothereisnoneedtohurry.
Note:Ifyouwantfasterblinkspersecondusepartystrobemodeandsetittothreeblinkspersecondor
more
 TempCheck:
BlinksoutthecurrenttemperatureindegreesC.andoptionallyconfiguresettingsforthermalregulation.
E.g.3blinks,thenpause,4blinkare34degreesCelsius.A"zero"isrepresentedbyaveryquickblink.This
numbershouldbeprettyclosetowhatarealthermometersays.Ifnot,itwouldbeagoodideatoclick4
timestoenterthermalconfigmodeandcalibratethesensor.
Group2Strobes:
(remembersthelast‐usedmode)fromOFF:"click,click,hold”
Clickthreetimes,butholdthethirdclickuntilthestrobemodestarts.Tochangetothenextstrobemode
useadouble‐click.
Tosetadjustmentsyoucanuse:
Hold:  Increasebrightnessorstrobefaster.(exceptlightning)
Click,hold: Reducesbrightnessorstrobeslower.(exceptlightning)
