Würth 0772 800 - Battery Test Procedure; Selecting Test Parameters; Surface Charge Elimination

16
Battery test (example)
BATTERIE TEST◄ ► ↵
××.×× V
Press the ◄ ► key to select battery test. Press Enter.
Press the ◄ ► key to select the battery type:
BATTERY TYPE ◄ ► ↵
AGM FLAT PLATE
a. REGULAR LIQUID
b AGM FLAT PLATE
c. AGM SPIRAL
d. VRLA/GEL
Conrm your selection with Enter.
SELECT RATING ◄ ► ↵
SAE
Select the test standard SAE, EN, IEC, DIN or JIS with the ◄ ► keys.
Conrm with Enter.
Press the ◄ ► key to select the battery capacity in CCA
SET CAPACITY ◄ ► ↵
×××× SAE
— SAE : 40~2000
— EN : 40~2100
— IEC : 30~1500
— DIN : 25~1300
— JIS : By battery, type, no.
Press Enter to begin the test.
Elimination of the surface charge
If the vehicle was running immediately before the test or the battery was charged, the battery probably has
a surface charge. The device may prompt you to remedy this surface charge before the start of the test:
Follow the instructions on the device display:
Battery installed
SURFACE CHARGE
IN VEHICLES? YES
→
TURN HEADLIGHTS
ON FOR 15 SECS
Battery removed
SURFACE CHARGE
IN VEHICLES? NO
→
TESTING
The test will be continued as soon as the tester detects that the surface charge has been remedied.
TESTING
Test the battery for 5 - 7 seconds.
IS BATTERY ◄ ► ↵
CHARGED? YES
Select one of the options with the ◄ ► key when the batteries are charged: Yes
or No
Conrm with Enter.