Würth ISS 45-M automatic - Page 23

GB - 7
– During the transport and maintenance of the
appliance the extraction opening is to be
closed with the connection socket.
몇 WARNING
Safety equipment for preventing haz-
ards must be serviced and maintained
regularly. This means that the manufac-
turer's staff or persons trained by the
manufacturer must check the equipment
for proper functioning at least once a
year, i.e. check for leaks, filter damage,
functioning of the controlling elements,
etc.
ATTENTION
Risk of damage! Do not use detergents
containing silicone to clean.
– No outside help is required for carrying out
basic maintenance and cleaning.
– The appliance surface and the inside of the
container should be cleaned regularly using a
damp cloth.
 DANGER
Risk due to dust hazardous to health. Al-
ways use disposal clothing and P2 or
higher breath-safe masks while carrying
out maintenance tasks (such as changing
filters).
 Open filter door.
 Take out the flat folded filter.
 Dispose off the used flat-folded filter in a dust-
tight bag according to the statutory provisions.
 Remove the dirt that has accumulated on the
pure air side.
 Insert new flat-folded filter.
 Close the filter door, it must lock into place.
Illustration
 Close the suction connection, see wet vacuum-
ing.
Illustration
 Release and remove the suction head.
 Pull the fleece filter bag towards the rear.
 Pull the locking slide up and seal the fleece fil-
ter bag tightly when removing it.
 Dispose of the used fleece filter bag in a dust-
tight bag according to the statutory provisions.
 Insert the new fleece filter bag.
 Insert and lock the suction head.
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Pull the opening of the disposal bag out to-
ward the back over the suction support and
seal it tightly.
 Tightly seal the disposal bag with closure strips
underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according to the
local provisions.
 Attach the new disposal bag.
 Pull disposal bag over the container.
 Insert and lock the suction head.
Illustration
 Release and remove the suction head.
 Remove the membrane filter.
 Pull the new membrane filter over the contain-
er edge.
 Insert and lock the suction head.
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
Exchanging the flat pleated filter
Replacing the fleece filter bag/dust
bag
Close the suction connection
Exchange the fleece filter bag
Replace the disposal bag
Replace membrane filter
Cleaning the electrodes
23