SET UP YOUR SCALE FOR USE
IMPORTANT! BEFORE USE:
1. Remove all packaging materials.
2. Remove the isolator tab from the battery compartment – without opening
the battery cover at the bottom of the scale, gently pull out the isolator tab.
(In case the tab cannot be pulled out, or if the scale display does not work
after you have pulled the isolator tab, remove the screw from the battery
cover and remove the cover. Gently pull out the isolator tab or any pieces
of it that may block the battery contacts. Ensure the battery is installed
correctly. Replace the battery cover and tighten the screw again).
3. Your scale is now ready to use.
For best accuracy, place scale on tile or hardwood oor, rather than
uneven, exible or soft ooring (such as carpet).
• The scale is set to (St) stones and pounds. For (Kg) kilos or (Lb) pounds,
press the button on the underside of the scale.
• Place the scale on a at, level surface for accurate operation and safety.
INSTRUCTIONS FOR USE
1 - Weight only
• Firmly and sharply Tap the centre of the scale with your foot.
Whole screen appears
• Then wait for ‘0:0’ to display
• Step on to the scale.
To Next Page
Loading...