Wyrestorm SW-0501-HDBT - 3 Preparation for Communication; Computer and Control System COM Port Settings; Computer IP Address Settings

6 of 14
SW-0501-HDBT / SW-1001-HDBT Presentation Switcher/Scaler Application Program Interface (API) | 151021-1044
3. Preparation for Communication
The following setting must be performed prior to communicating with the switcher.
Computer and Control System COM Port Settings
The following parameters must be set in the computer or control system COM port in order to communicate with the switcher.
Baud Rate:
9600
Parity:
None
Data Bit:
8
Stop Bit:
1
Computer IP Address Settings
The computer and the switcher must be on the same subnet in order to communicate. Set the computers IP address range of
the switcher.
Example: If the IP address of the switcher is 192.16.1.24, set the computers IP address to 192.168.1.x where x is number
between 2 and 254 that is not used by other devices on the network.